Continue to adjust levels, panning, EQ until you have the sound you desire.Įncompasses sounds which are often felt more than heard. If you hear anything you want to change, do so and then move around the room listening to the sound from different perspectives (remember, what sounds decent in one place can sound not so great in another). Once all channels (instruments/mics) have been un-muted, EQ'd and sound decent solo, have the band play a song. If clipping occurs before this point, decrease gain by 10-20% as excessive clipping can damage the speakers.Ħ. If none, slowly increase amp gain until either clipping occurs or you reach roughly 75% gain. While the band is playing at full volume, go to the amp rack and make sure there is no clipping happening in the system. If need be, have the musician play solo so you can hear clearly.ĥ. Set a rough EQ for each channel as you do this. Set gain structure for each channel, un-mute the channels one at a time and slowly increase the fader volume. Turn on the amplifiers with gain knobs turned completely down, increase gain knobs to no more than roughly 50%.Ĥ. Turn on Mixer/Soundboard and make sure the gain knobs are all down, the channels are muted, and the main volume faders are pulled completely down.ģ. Make sure all mics and instruments are plugged in to the snake and any powered instruments (keyboard, electric acoustic guitar, etc.) are turned on.Ģ. Before you begin, make sure the snake is properly connected to the mixer, the mixer is connected to the amplifier rack correctly, the power supply for the amplifiers is plugged in but powered down, and the speakers are plugged into the amplifier rack.ġ.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |